[Elecraft] Installing Middle Screws on KPA100 Side Panel

[Roy Morris]

I do not think the ovrsized screws are the answer for the K2/100.  Over time I don't believe they will remain tight if you go into the K2 enough times and might even strip.  For this reason I have never put a screw in that hole.  I am thinking of drilling a hole at the precise right place in the first cooling fin, tapping the hole and putting in a long enough screw that will hold.  I don't think the screw would be noticable if it is the same color as the other screws.  What do some of you think about this?   Roy Morris  W4WFB
-------------- next part --------------
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.394 / Virus Database: 268.7.1/348 - Release Date: 5/25/2006