[Elecraft] more on the KPA800/1500

[wayne burdick]

In the KPA series, we're using a different construction technique than 
that of other amps. Rather than interconnect modules using a slew of RF 
and control cables, we use a single large motherboard, into which all 
functional modules simply plug in. (It's very Elecraftish, and looks 
better, too :)

The modules are arranged on the mother board in the same locations as 
they appear on the electrical block diagram. This makes signal flow 
very clear to the builder or service tech.

As a result of this arrangement there are far fewer cable assemblies, 
improving reliability. It's also quite simple to swap modules in/out in 
the field, should that ever be necessary. Complete diagnostic hardware 
and firmware is included to isolate modules that might have to be 
replaced.

73,

Wayne, N6KR


---

http://www.elecraft.com