[Elecraft] K2 VCO Shield instructions - Freq Counter probe

[Richard Kent]

Last week there was a thread about this. Leaving the probe in increased some
spurs in the transmitter output. Values were not given, but it sounds
removing it is the better idea. When you are done tweaking the filters take
it out.
Rick WD8AJG K2 #5296

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of N2TK, Tony
Sent: Tuesday, May 09, 2006 6:39 AM
To: Elecraft (E-mail)
Subject: [Elecraft] K2 VCO Shield instructions - Freq Counter probe

Just installed the K2 VCO Shielding Upgrade. The instructions say to
disconnect he frequency probe and completely remove it from the K2. I used
to leave it in TP2. Does it really make a difference with anything by
leaving it in TP2?
Tnx
N2TK, Tony
#3481


_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com