[Elecraft] VFO A/B modes?

[Jim Wiley]

Chris -

I don't think there is a way to do this.  I have wanted to do the same 
thing, but so far, no luck,  Perhaps one of the future firmware 
revisions will include this feature.  Like you, I also prefer to have 
one VFO on CW and the other on SSB.  Actually, it would be very helpful 
to be able to have the last mode used on a band, together with which VFO 
was active,  be remembered too.

I am not sure how much storage room is available for that sort of thing 
in the software.  We're probably both a bit spoiled by the features on 
our Mark V's - Hi!    Still, I do love the quietness of the Elecraft 
receiver.


- Jim, KL7CC


Chris Hurlbut wrote:

>Is there a way to make the VFO A/B change modes?  I know it keeps the
>same mode per band... seems everything is "per band" if I read the
>manual correctly.  
>
>Normally I keep VFO A on CW, and VFO B on SSB, on each band.  Is there a
>way to do this without having to switch modes manually each time I swap
>VFO's?  Like when I am on 7005 CW and go to VFO B, I'll be on 7185 CW,
>instead of LSB.  Can this be done?
>
>Thanks!!
>
>-Chris KL9A
>
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft    
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com
>
>
>  
>