[Elecraft] KDSP2 low pass and bypass problems

[Lyle Johnson]

> 2/ BYPASS MODE
> The bypass mode can be set to DSP BYP using the menu.
> However, this does not actually bypass the KDSP2. 

Please note the current the K2 is drawing (use the DISP button) when in 
operating mode and in bypass mode.  If the current drain is reduced, the 
KDSP2 is bypassed and the effect is from something else, perhaps the 
current crystal filter setting.

In bypass mode, the DSP goes into a low power mode and the CODEC is 
mostly turned off, just leaving the analog section operating to pass the 
signal through.

73,

Lyle KK7P