[Elecraft] K2 dimensions

[Don Nesbitt]

No - approximate height of mine with feet is 3 3/8 plus a "tad" - total 
about 3 7/16 allowing for the screw heads - width almost exactly 8 " 
(including screw heads) and (here is where it gets tricky) depth about 10 
inches (+ or - depending on if you have finger dimple installed or not) from 
farthest front protrusion to farthest rear protrusion (end of bnc's) - if 
you have the KPA100, the SO-239 sticks out about as far as the BNC's - now 
if you plug in the key plug, power poles ( if you have the KPA100), KIO2 
connector, etc, etc, there is more measuring to do!

Bet that was more than you wanted to know!  -- 73 -- Don N4HH

----- Original Message ----- 
From: "Daniel Reynolds" <aa0ni at yahoo.com>
To: <elecraft at mailman.qth.net>
Sent: Tuesday, March 28, 2006 9:49 AM
Subject: [Elecraft] K2 dimensions


> Do the K2 dimensions (7.8 x 8.2 x 2.9) include the knobs, rear BNC 
> connectors,
> and rubber feet?
>
> Thanks,
> Daniel AA0NI
>
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.385 / Virus Database: 268.3.2/294 - Release Date: 3/27/2006
>
>