[Elecraft] RE: Info Message 090

[Mike Short]

I resoldered the display. There were some questionable joints.
I also found that during shipping two components on the bottom of the RF
board had come loose, etc. After carefully inspecting the board, cleaning
the flux, etc I found a couple of bridges. Works great now, and I am almost
done with Part 2. Thanks to all who replied.By the way, the Rework
Eliminators are an excellent product, and I highly recommend them. 

Mike 
AI4NS


I fired up the partially assembled K2 I purchased, and I get an info message
090.Says it is an EEPROM test #1 failed. Also the display is does not show
all segments, and the  Tuning knob has no effect. I did a complete reset
with no effect. I am at Alignment and Test Part 1.