[Elecraft] K2 AGC off problem

[Dr. Werner Furlan]

hi all, 

I should have posted this before...
I found a related message when searching the archive. The reply was:

------------------
Sounds exactly like the problem I had with 5196. The problem was fixed by
replacing X1 on the Control Board. You will probably find that CtrlBd-U2-1
goes to about 6 volts when you turn the AGC OFF virtually shitting down the
IF amplifier. I encourage you to communicate with Gary
(support at elecraft.com) regarding this problem. Yesterday, someone 
reported a
similar problem with a close serial number(s/n5219).
----------------------

My serial # is 5203, so maybe I am also affected by this failure?

73! de Werner OE9FWV

-- 
EYEDROPPER:  A clumsy ophthalmologist


Email powered by Pegasus Mail free at <http://www.pmail.com>
Homepage: <http://www.qsl.net/oe9fwv/>
Fone +43 5522 75013
Fax +43 820 555 85 2621
Mobile      +43 664 6340014
Elecraft K2 #5203