[Elecraft] K2 build - Control board Resistor SIPs not marked right.

[Fred Jensen]

Ian Stirling wrote:

> The most important step in my opinion is to
> do a full inventory, at the same time partitioning
> components that look similar to separate marked
> locations.  

I strongly second Ian's inventory comment, and his reasons for doing it. 
   It's a bit of a drag, and we all want to heat up the solder station 
and start the "real" building, but a complete inventory will likely 
prevent micro, mini, and mega disasters.

Also, beware of inadvertently mixing up a part value with a reference 
designator, there are a lot of words in the assembly instruction book, 
and nearly all of them are important!  (e.g., and speaking from 
experience, starting to install "C25" and fetching a 25pf cap for it 
when the real value is 15pf)

Fred K6DGW
Auburn CA CM98lw