[Elecraft] K2 SPLIT MODE AND LOGGER 32

[Chris Page]

A few days ago I asked if anything could be done to prevent the K2 
being switched out of Split mode when I click on a DX Cluster spot in 
Logger 32.

As a result of the replies from K8DD, KD0ZV, WG4S and W3FPR, I asked 
the Logger 32 Development Team about the problem.  I have just 
received the e-mail below from Geoff, G3NPA.

I haven't approached the N1MM Logger team about the problem (as the 
same thing happens when I click on a DX Cluster spot in that program) 
as I anticipate their reply will be much the same as Geoff's.

I seem to be going round in circles and guess I will have to learn to 
live with the problem - a pity because this is the first time that 
using my three K2s at two different QTHs has caused me not to like 
something about using them.

73 de Chris, G4BUE

From:           	"Geoff Anderson" <geoff.anderson at btinternet.com>
To:             	<g4bue at adur-press.co.uk>
Copies to:      	"Hal Miller" <kb1zq5 at swbell.net>
Subject:        	Re: LOGGER32
Date sent:      	Wed, 15 Mar 2006 14:29:03 -0000

> Is there any way round this so that the K2 stays in Split mode
> when I click on a spot, please?

The answer to your question is basically no.  The K2 uses the same
command set as the Kenwood series of radios and in that case also the
FR command will take the set out of split mode.  It is a function of
the radio and not Logger32.

Incidentally Logger32 does NOT support split mode working either - 
but that is a slightly different matter

73 de Geoff
G3NPA
Geoff.Anderson at btinternet.com