[Elecraft] Callsign Software

[Rich McCabe]

For those of you that have RealPlayer installed and a broadband connection 
(and have interest)..........

I was did a screen video capture of the Callsign K2 software today. This 
version is in BETA and is getting close to release.

The K2 serial interface has been a challenge to say the least and because of 
this several areas have special timing profilers built into to slow the 
radio commands down to a point where the K2 can keep up.

Currently, the DSP section is undergoing a major workover to speed commands 
up. Not a problem with the DSP itself but apparently the K2 auxbus.

You will notice that DSP filter buttons are labeled from querying the DSP. 
There is also LC and HC +/- buttons so you can set your upper and lower 
filters from the software. The NR has adjustable parameters as well.

Anyway, its a "CRUDE" run through of the radio. Thought I would share with 
the group. I am guessing this version will be available in the next two 
weeks depending on how timing issues work out.

Here is a link to the video file. As I said it requires RealPlayer and 
around a 450K broadband connection.

http://www.callsignsoftware.com/mike.ram

73,
Rich
kd0zv