[Elecraft] OT: Looking for parts for old test equipment

[Howard W. Ashcraft]

I know this is OT, but the group usually has good suggestions.

I am repairing a Fluke 6080a/an signal generator.  As it turns out, in its prior life, someone damaged the A5 coarse loop vco board, and it looks like I will need a new board, not just component replacements.  There is a Tektronix reflector that is often helpful in finding Tek parts.  Can anyone point me to a usenet group or otherwise where information and parts for older test equipment, such as the Fluke, can be found.  I would really like to resurrect this generator as it mostly works, is very nicely built, and has good ergonomics.

Regards,


HOWARD W. ASHCRAFT, Jr.
Direct Dial: (415) 995-5073
hashcraft at hansonbridgett.com 
HANSON 		425 Market Street, 26th Floor
BRIDGETT		San Francisco, CA 94105-2173
MARCUS  		Direct: (415) 995-5073
VLAHOS		Main: (415) 777-3200
RUDY, LLP		Fax: (415) 541-9366 







*****************************
This communication, including any attachments, is confidential and may be protected by privilege.  If you are not the intended recipient, any use, dissemination, distribution, or copying of this communication is strictly prohibited.  If you have received this communication in error, please immediately notify the sender by telephone or email, and permanently delete all copies, electronic or other, you may have.

To ensure compliance with requirements imposed by the IRS, we inform you that any tax advice contained in this communication (including any attachments) was not intended or written to be used, and cannot be used, for the purpose of (i) avoiding penalties under the Internal Revenue Code or (ii) promoting, marketing or recommending to another party any transaction or matter addressed herein.

The foregoing applies even if this notice is imbedded in a message that is forwarded or attached. 
*****************************