[Elecraft] K2 SSB

[Rich McCabe]

Well I think so too. So one step forward and one step back. Got it working. 
Was a bad solder joint. Sure looked good but did not test out with the meter 
!  Some of those caps are in rather tight spots :)

So the "last" step back was during reassembly. The center connector on the 
RF cable where it solders to the 100watt board broke loose. That looks like 
its gonna be a little work. Cant get at the side of the board I need without 
taking it apart. Dont think anyway. Back to soldering.

Thanks Don. All is good now. This 2.6 should sound a LOT different than the 
2.1. Hope so anyway.

73,

Rich


----- Original Message ----- 
From: "Don Wilhelm" <w3fpr at earthlink.net>
To: "Rich McCabe" <r.mccabe at 1967z28.com>; <w3fpr at arrl.net>; 
<elecraft at mailman.qth.net>
Sent: Thursday, March 09, 2006 9:44 PM
Subject: RE: [Elecraft] K2 SSB


> Yes, that is entirely possible, and in your case it looks like that is the
> situation.
>
> 73,
> Don W3FPR
>
>> -----Original Message-----
>>
>> I thought they came at the same time? So its possible to have the "-s"
>> crystals in a 2.1 khz setup?
>>
>> Rich
>>
>
>