[Elecraft] I/O Port issue?

[Don Clark]

Thanks Bill.  The answer is yes to all of your questions.

Don

----- Original Message ----- 
From: "Bill Coleman N2BC" <n2bc at stny.rr.com>
To: "Don Clark" <kes4845 at cox.net>
Sent: Saturday, March 04, 2006 9:50 PM
Subject: Re: [Elecraft] I/O Port issue?


> Hi Don,  did you turn it on in the K2???   SECondary menu, Port = ON
>
> Make sure the programs are set to 4800 baud, 8 bits, no parity, 1 or 2 
> stop bits.
>
> (Something I trip over all the time) Are you sure you have the correct COM 
> port number on your PC?   Now-a-days the COM port number is configurable, 
> check the windows control panel entry.
>
> Good luck!
>
> 73, Bill  N2BC
>
> Don Clark wrote:
>> I want to control my K2 via my computer.  My I/O port was built when I 
>> built the KPA100 last summer.  I have built the cable and have double 
>> check the connections.
>> Using Hyperterminal, I receive no info from the K2.  I also receive 
>> nothing from the K2 when using Ham Radio Delux.  I use this program with 
>> my FT-1000D successfully.
>>
>> I am able to send commands to my K2 and have it react correctly.  There 
>> isn't too much documentation in the manuals about the I/O port.  Does 
>> anyone have any ideas on where I should look first?  Again, I have double 
>> checked the cable.
>>
>> Don - KA6AKH K2 - 1683
>> _______________________________________________
>> Elecraft mailing list
>> Post to: Elecraft at mailman.qth.net
>> You must be a subscriber to post to the list.
>> Subscriber Info (Addr. Change, sub, unsub etc.):
>>  http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/subscribers.htm
>> Elecraft web page: http://www.elecraft.com
>>
>>
>>
>