[Elecraft] Coax Switch between two rigs

[Tom Althoff]

I too use the Alpha-Delta to switch between my K2/100 and my K1 with no 
problems.  I've actually tuned the K1 to my K2 signal to listen to the 
signal.

Tom K2TA
----- Original Message ----- 
From: "Bob Nielsen" <nielsen at oz.net>
To: <elecraft at mailman.qth.net>
Sent: Wednesday, March 01, 2006 9:18 AM
Subject: Re: [Elecraft] Coax Switch between two rigs


>
> On Mar 1, 2006, at 6:06 AM, Lee Buller wrote:
>
>>
>>   OK....I know that this might be a dumb questions, but before I do  a 
>> dumb thing I want to ask the question.  I have two rigs...one of  which 
>> is the K2/100.  I have a two position coaxial switch (I think  it is a 
>> Diawa CX201A) that I picked up at a hamfest. Is there  enough isolation 
>> between the two positions where I could switch  between two rigs?  I 
>> don't want to blow out the front end of either  rig.  I would think that 
>> if you are using one rig, the other rig  shouldn't be on or if it is on 
>> should not be on the same band.   Again, would this be something stupid 
>> to do or is it something that  is done routinely?
>>
>>   Lee- K0WA
>
> I am not familiar with the Daiwa switch, but the ones I use (Alpha- Delta 
> and MFJ) ground the unused sections and the isolation is quite  good.
>
> Bob, N7XY
>
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com