[Elecraft] K2/100SSB partial disassembly/assembly help

[Joseph Reed]

Don,
 
You are so correct and most of us who have built them are all to framiliar with the process.  Since Mark is going to use a Kenwood microphone there might not be any need to pull the front panel,  just the control board.  (Unless the builder soldered the jumpers.)
 
Taking a leap of faith, it should (hopefully) be  just pulling off the existing header and jumpering across the pins with standard jumpers that are available at Radio Shack everywhere.
 
Regards,
Joe N9JR

----- Original Message ----
From: Don Wilhelm <w3fpr at earthlink.net>
To: Mark <m2steven at bellsouth.net>; elecraft at mailman.qth.net
Sent: Friday, June 30, 2006 1:33:39 PM
Subject: RE: [Elecraft] K2/100SSB partial disassembly/assembly help


Mark,

OK, there needs to be a document 'How to disassemble your K2' for those who
purchased the K2 already built.  Sure the instructions are there in the
manual, but they are spread out over the entire manual since that is
something that is learned in pieces during the build process.