[Elecraft] K2 RF Board TP3

[Ron D'Eau Claire]

Mark G3XYS asked:
Is there any reason why I cannot mount TP3 (PLL Reference Oscillator 
Test Point) on the underside of the RF board instead of on top.  This 
will give easier access for frequency checking after K2 completion.  A 
suitable hole drilled in the bottom cover and plugged with a bung (like 
one from an inkjet cartridge refill set).

-----------------

Why would that be easier? You still need to get inside the top of the K2 to
plug the test cable into the control board connector, and you'd need a
longer cable than specified in the kit. 

Besides, it's not something one needs to access very often...

Ron AC7AC