[Elecraft] KXB30 installation problem on a KX1

[Don Wilhelm]

Paul,

Yes, put the pads in place just in case anything shifts later.  You could
tape them in place, use rubber cement, a dab of 'Shoe-Goo' or any other glue
that is advertized to bond with both rubber and fiberglass.  Most glues will
bond with the fiberglass, but few will stick to rubber.  You only need a
tiny bit.

73,
Don W3FPR


> -----Original Message-----

>
> Under these circumstances should I …
>
> a) just leave off the rubber pads?
>
> or
>
> b)  use a drop of glue (what kind) to attach the pads to the KXB30 board?
>
> or
>
> c)  just install one of the rubber pads at the center of the
> KXB30 board where
> there are no solder pads?
>
>
> Thanks in advance for any advice that you can offer!
>
> 73,
> Paul – N8XMS
>
>
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.394 / Virus Database: 268.9.1/369 - Release Date: 6/19/2006
>
>