[Elecraft] KIO2 programmers question: SCAN

[Nick Waterman]

Just been checking the KIO2 Programmers Reference (as used by the KPA100
AUX IP port too). It doesn't seem to be particularly easy to use the
K2's scanning modes from the serial interface, and perhaps even
impossible if I want to scan with "AF ON"?

Presumably it's considered easier to do something like:

FAnnnnn;      [set VFO A freq]
UP;           [up 10Hz]
UP;
UP;
...

or UP3;UP3;UP3; or whatever? This would work, would give me more
feedback/control over exactly where the frequency is right now, but
seems to be an awful lot of commands to achieve something the K2 can do
itself.

Any other ideas, and/or have I missed something?

Thanks

-- 
"Nosey" Nick Waterman, G7RZQ, K2 #5209.
use Std::Disclaimer;    sig at noseynick.net
After a number of decimal places, nobody gives a damn.