[Elecraft] KX1 Problems?

[Don Wilhelm]

Dave,

If your power supply is 13.8 volts, you can expect more power output than
that.  Check into a known good 50 ohm dummy load with the tuner removed and
the jumper in place.

If you still have problems, check T1 and the Low Pass Filter (L1 and L2 and
associated capacitors) for proper winding, good lead stripping, and proper
values.

A typical KX1 will provide almost 4 watts out on 40 meters and about 3.5
watts on 20, but anywhere in the range of 3 to 4 watts is the specification,
so if you can get both bands above 3 watts, it passes.

The receiver sensitivity is not related to the transmit problem unless you
have a gross error in the Low Pass Filter - differnt circuits are used for
transmit than those for receive (the trimmers are only for the receiver
front end tuning, not transmit).

73,
Don W3FPR


> -----Original Message-----
>
> I just finished my KX-1. I am not sure if I have problems or not.
> The output
> power into a dummy load is only 2 watts. I completed the power
> mod replacing
> resistors R11 and R30 which made little or any difference. Also
> the receiver
> sensitivity seems noticeably better on 40 meters. Any comments?
>
> Dave N1IX
>
>
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.394 / Virus Database: 268.10.5/403 - Release Date: 7/28/2006
>
>