[Elecraft] Yaesu MD-200A8X mic on my K2

[JEAN-FRANCOIS MENARD]

I found it !!! For a reason that I cannot explain.... I put earlier on 
the control board a jumper over FUNC on P1 header.... and should not be 
there. Now, everything works fine. With my Kenwood MC-43 mic... no 
problem... but with Yasesu mic, it was affected by this jumper. Anyway, 
no extra function is available when using this jumper.

73



JEAN-FRANCOIS MENARD a écrit :
> Hi,
>
> I very confused, I'm trying to connect my Yaesu MD-200A8X mic to my 
> K2. I changed all wiring of the Yaesu mic to match my other Kenwood 
> mic. I don't want to change jumper block on the control panel... and 
> the Yaesu mic will be used exclusively on my K2 now.... but for 
> outdoor operation, I will use the Kenwood hand mic... so this is why I 
> changed the Yaesu mic connector to match my Kenwood mic connector.
>
> If I push UP or DOWN... OK VFO A or B selected...... When I push 
> PTT.... it transmit.... but when I release the PTT button.... freq. 
> change to VFO A or vice-versa...
>
> Any idea what I have done wrong.. ??!?!?!?
>
> Thanks
>
> J-F VA2VYZ
>
> __________________________________________________
> Do You Yahoo!?
> Tired of spam?  Yahoo! Mail has the best spam protection around 
> http://mail.yahoo.com _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft   
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com