[Elecraft] KPA100 question

[Ron D'Eau Claire]

The positioning of R10 is critical for stable operation. See the bottom of
page 2 of Errata C-7, if you haven't looked at it already. If you don't have
the errata, it's available on the Elecraft web site (www.elecraft.com). 

Ron AC7AC

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of John Wiener
Sent: Wednesday, July 12, 2006 5:18 PM
To: Elecraft email
Subject: [Elecraft] KPA100 question


Hey, everyone!

I'm working on page 30 of KPA 100 manual.  I am ready to connect J2  
(SO239) as directed.  I seem to remember a modification using an RFC  
in there somewhere.  I can't remember where I saw it.  A brief review  
in the reflector site was a blank.  Any ideas before I proceed?

Thanks!

John
AB8WH
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com