[Elecraft] Optimising the PA stages
John A. Ross [Ecraft]
john_kx at rsdtv.com
Sat Jul 8 21:07:38 EDT 2006
> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Ron
> D'Eau Claire
> Sent: Sunday, July 09, 2006 1:52 AM
> To: elecraft at mailman.qth.net
> Subject: RE: [Elecraft] Optimising the PA stages
>
> There is an optimizing mod to one toroid for the K2 IF you
> are going to work at 5 watts or less, maximum. It'll reduce
> the xmit current a bit to help those using he QRP K2 with
> internal batteries. The flip side is that the rig is less
> efficient at higher levels.
>
> It's on the Elecraft web site (www.elecraft.com) under
> Builder's Resources.
Ron
Thanks, I already found that one.
It actually mentions it in the schematic in the manual but applies only to
T4 turns ratio I think.
At the moment its working quite well, its in my nature to be curious though
;-)
I am going to have plenty fun with it either way.
All best
John
>
> Ron AC7AC
>
> -----Original Message-----
> Hi All
>
> Ser Nr 5544 is now alive and kicking.
>
> When doing the Align/Test P III with the referenced power
> level setting of 10.0W I find the current level hovering
> around the upper limit of the recommended range at 2.0 amps
> although I did not see any Hi Current warnings.
>
> All the RX/TX alignment also seems OK. Is there any published
> tables on typical performance variance across the bands
> regarding signal level in for say S9 or MDS? or typical power
> levels out?
>
> This leads me to believe that some optimising can possibly be
> done, or I have some stages slightly off the intended specs.
>
> I was sure I seen some posts previously on alternate winding
> of the transformers in the TX chain from T1 onwards but I am
> getting way to may hits from the 11k messages I have archived
> from this list to be able to filter them down easily.
>
> Any information appreciated.
>
> John
>
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
More information about the Elecraft
mailing list