[Elecraft] KAT100-1 Measurements?

[Darrell Bellerive]

Would someone be so kind as to take some measurements of the KAT100-1 Antenna 
Tuner:

The horizontal distance between the center of the Antenna 1 SO239 connector 
(J5) and the center of the Antenna 2 SO239 connector (J6).

The horizontal distance, parallel to the back panel, from the center of the 
Antenna 2 SO239 connector (J6) to a projection of the outer edge of the left 
side panel. In other words, how far in is the center of the Antenna 2 SO239 
connector from the outside edge of the left side panel?

The horizontal distance, parallel to the back panel, between the center of the 
Antenna 1 SO239 connector (J5) and the vertical center line of the ground 
screw (E1).

I am building a new feed-through panel and want to make it line up properly 
with a KAT-100-1 which I have not yet purchased. There will be short runs (2 
inches or so) of coax between the feed-through panel and the tuner, so the 
measurements don't have to be exact. The coax will compensate for a slight 
offset.

Thanks in advance!

Darrell   VA7TO   K2#5093 

-- 
Darrell Bellerive
Amateur Radio Stations VA7TO and VE7CLA
Grand Forks, British Columbia, Canada