[Elecraft] Newbie requests advice

[Craig Rairdin]

When building my K2 I found it helpful to look at photos of other K2's if I
was confused about a part. I couldn't always find exactly the view I was
looking for, so I took my own page-by-page photos of my K2 being built. Go
to www.craigr.com/coppermine and select the Ham Radio, 2005 category. You'll
find the K2 pictures in there.

Have fun!

Craig
NZ0R
K1 #1966
K2/100 #4941

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of recarter at adelphia.net
Sent: Friday, January 27, 2006 12:05 PM
To: Elecraft at mailman.qth.net
Subject: [Elecraft] Newbie requests advice



I just received my new K2, SSB and 160M options too.  I've also ordered the
rework eliminator kit.  I've redlined my insructions with errata and rework
updates.  Assembly starts tonight.  

I've hunted around for a general advice thread, but there is so much
information out there I can't seem to sift out what I'm looking for.  I know
the hot end of a soldering iron from the cold end, and I have some test
quipment including scope and signal generator.  If anyone out there has
adice or can point me to the right place, please reply.  In particular, if
anyone has experience with the rework eliminator please reply.  I'm
concerned that the test and alignment procedure may not work as it should
with these mods.