[Elecraft] VFO A/B mode settings

[Trevor Day]

Regretfully thats normal Stan.  Independent VFO mode setting is facility 
that I would dearly like to have though.

Trev G3ZYY

In message <005b01c62224$ae32ce10$6401a8c0 at stansdesktop>, Stan Rife 
<srife at swbell.net> writes
>       I don't think I have a problem, it is more likely operator error. On
>any given band, when I switch from VFO A to B, the mode does not change to
>what I had previously set VFO B to. If I am LSB in VFO A and I switch to VFO
>B, I set the mode to CW, tune around for a while, then go back to VFO A and
>it remains in CW mode. It doesn't switch back to LSB for VFO A. Is this
>normal? I thought I remembered that the mode was saved for each VFO.
>       I guess I need to read the manual again, after 2 years.
>
>Stan Rife
>W5EWA
>Houston, TX
>K2 S/N 4216
>
>
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com

-- 
Trevor Day
UKSMG #217
www.uksmg.org