[Elecraft] Construction question

[Clint Sprague]

I'm attempting my 1st contruction project in many
years...
CMOS4 keyer, and I have what is probably a pretty
stupid question that maybe others can answer for me
here.  When you install a component on the printed
side of the circuit board, and then you tip the board
over to solder, what are accepted methods to keep the
compenent from falling off?  I've read
that you should bend the leads to hold the component
onto the board
but I was wondering if this is the only acceptable
way?

Thanks for you info,
73 - Clint - WS1V

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com