[Elecraft] Remote control software

[Richard Carter]

After looking at the help pages, I don't see anything that would allow
configuring the radio menus such as filter bandwidth settings etc.  I can't
run the program with my K2 yet because I have yet to build the 100w
amp/serial interface.  Are you sure this lets you configure the menus?
Thanks
Rich KE1EV

http://www.richardcarter.net/ 

> -----Original Message-----
> From: G8IFF/KC8NHF [mailto:nigel at ngunn.net] 
> Sent: Sunday, February 26, 2006 2:22 PM
> To: recarter at adelphia.net
> Cc: Elecraft at mailman.qth.net
> Subject: Re: [Elecraft] Remote control software
> 
> Ham Radio Deluxe, amongst others may help.
> http://hrd.ham-radio.ch
> 
> 
> Richard Carter wrote:
> 
> >At the risk of sounding like I'm criticizing the K2, I'd like to say 
> >that the menues are awkward to set.  Unless I have a cheat-sheet of 
> >some kind, I can't find my way through them.  I suppose this 
> isn't such 
> >a big deal because most of the menue settings are a set once 
> and forget 
> >or at least a rare change.  It would be so much easier if 
> there were a 
> >remote control application that allows access to the K2 
> menues, but I 
> >can't find one.  Does anyone know of such a program?
> >
> >http://www.richardcarter.net/
> >
> >
> >  
> >
> 
>