[Elecraft] K2 RECEIVER: WHERE ARE THE SIGNALS?

[Don Wilhelm]

Manuel,

No need to re-do the alignment.  Later, you will re-peak L1 and L2 in the
transmit mode as a final step which provides a more defined peak than one
can hear in receive.  A signal generator will not be required.  If you tuned
L34 with the weak 7000 kHz birdie as instructed in the manual, that is
correct, no re-do is necessary.

73,
Don W3FPR

> -----Original Message-----
>
> I had my 160 plug-in Rework Eliminator plugged-in backwards...
> ...
> Because of the header's position shall I do the whole
> calibration/alignment
> step-by-step  (page 60 to page 64) procedure of PART II all over
> again? I am
> also concerned about final adjustments of L34 and L1+L2 as I have
> to rely on
> regular noise to do that. No signal generator here. The 7000 khz weak
> internally-generated signal is there.
>