[Elecraft] K2/100 in QRP mode?

[Don Brown]

At least two ways. One unplug the power connector to the KPA100 and use the 
old round power connector on the K@ it will auto detect and go into QRP 
mode. Two, go into the secondary menu and turn off the KPA100. Of course you 
can also remove the KPA100 and install the QRP top but that is really not 
necessary un less you want to use the battery option then you would neet to 
either swap the tope or the ultimate is to build the KPA100 into an EC2 box 
then you can just unplug the K2 and go. You can also have the KAT100 live in 
the EC-2 box with the KPA100

Don Brown
KD5NDB


----- Original Message ----- 
From: "Darwin, Keith" <Keith.Darwin at goodrich.com>
To: "Elecraft Discussion List" <elecraft at mailman.qth.net>
Sent: Thursday, February 23, 2006 10:55 AM
Subject: [Elecraft] K2/100 in QRP mode?


What does it take to make a K2/100 run QRP?
  - Turn down the power? (fine for CW what about SSB?)
  - Unplug the KPA100 and put the old top back on?

- Keith KD1E -
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com