[Elecraft] power output of K2

[Ian Stirling]

On Tuesday 21 February 2006 18:25, Don Wilhelm wrote:

> An RF Probe or 'scope to measure the RF Voltage along with an accurate
> non-reactive 50 ohm dummy load will provide much better accuracy (except
> when the wattmeter has been properly calibrated at the power output that it
> is being used to test the K2.

Don,

  There's another suggestion, thankyou.
I'll try using a digital volt meter,
eleven megohms input impedance, with the
probe I made during my K2 construction.
  It will be an interesting cross check.

Ian, G4ICV, AB2GR, K2 #4962
--