[Elecraft] Heil Handi Mic Configuration Question

[Gottlieb, Jonathan]

I am finishing up K2 #5113 and have run into a snag configuring the
microphone on the K2SB2.  I am using a Heil Handi Mic HM-IC.  Bob Heil
told me to get this mic as he said it would optimize my 706 MKIIG and
the K2.  I'm using the Kenwood 8 pin cable for the K2, again per Heil's
recommendation.  I've set up the P1 on the K2SB2 for the Kenwood mics
using block jumpers.   Setting the K2 power for 2 watts, when I push the
PTT, I'm getting a carrier at over 10 watts out.  No modulation when I
speak, just a constant key down carrier at a very high power output.
I'm using a very reliable and accurate Waters analog watt meter.  Any
ideas on what I've done wrong and what I need to do to fix this?
 
Jonathan Gottlieb
WA3WDK
K2/100 # 4853
K2 #5113







____________________________________________________________________________________________________________

CONFIDENTIALITY NOTICE: The information contained in this e-mail is confidential, may be legally privileged, and is intended only for the use of the party named above. If the reader of this is not the intended recipient, you are advised that any dissemination, distribution, or copying of this e-mail is strictly prohibited. If you have received this e-mail in error, please immediately notify us by telephone at 612.335.1500 and destroy this e-mail.
____________________________________________________________________________________________________________