[Elecraft] Stripping Enamel Wire (WAS: OT solder pot)

[Don Brown]

Hi

If you happen to own a Hakko 808 desoldering gun then you can insert the 
toroid wire into the nozzle up to the core on the toroid. Then feed a little 
solder and pull the trigger. The enamel will be stripped off and the wire 
cleaned and tined all at the same time by the rush of air over the wire. 
This whole process takes about 10 seconds and gives perfectly stripped and 
tined leads. The only thing better is to buy them already wound, stripped 
and tined from the toroid guy

Don Brown
KD5NDB