[Elecraft] can rf interference get into a k2?

[Ed - K9EW]

A good starting point would be to operate into a dummy load.  If there's no
interference, then you're dealing with energy radiating from the antenna -
not a K2 problem.  If there is interference, that narrows the possibilities
to the K2, the dummy load, the coax, and ... the power supply.

Hope this helps.
ed - k9ew


On 2/2/06, jferg977 at aol.com <jferg977 at aol.com> wrote:
>
> I'm having problems with rf interference when attempting to transmit.
> I have a list of possibilities which don't need exposure here, but I do
> want to know if the K2 with the rear cover it comes with with all of
> the unfilled openings can allow rf into a place where it could be a
> problem?
>
> Should I block the holes?
>
> I would be delighted to find out this isn't a possibility in any case,
>
> 73,  John Ferguson KI4NGH
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>