[Elecraft] KX1 and KXB3080 build suggestion

[wmorrill at montana.edu]

After completing a KX1 kit and I ordered and built the 30/80 adapter.  The
conversion required removal of several capacitors, resistors, toroids, and
a choke that were originally installed on the KX1 board.  If you are
anticipating installation of the adapter, I suggest a careful evaluation
of the assembly manuals to determine which new components will be needed. 
Installation of these new components during the original construction of
the KX1 would eliminate desoldering and removal of the old components. The
desoldering method that works best for me is to heat and remove the
component.  Then, reheat and quickly blow on the area to clear melted
solder.  Close placement of components on the KX1 board prevents the use
of a solder sucker.