[Elecraft] KPA - High current

Smythe smythe12 at comcast.net
Fri Dec 22 20:38:26 EST 2006


I've been trying to make the SWR bridge Null adjustment.  R26 and R27 are
tuned to 43K.  I'm connected to a dummy load.  When I go into tune mode on
40 meters I continue to get a high current warning and the display reads .1
watts and swr 1.0:1.  I removed the board from the heat sink and checked
connections, solders and component orientation twice.  The unit is solid and
works fine without the KPA connection I believe.

 

I'm lost.  Any ideas?  



More information about the Elecraft mailing list