[Elecraft] 10M birdie and other assundries
Michael E. Dobson
vze3xrrt at verizon.net
Tue Dec 19 19:33:00 EST 2006
I don't know how reduced it is because I haven't compared it to the
KPA100 as the top lid but it is barely noticeable in my K2 with the
KPA100 in an EC2 unless I have the preamp on. Even then, it is more
a nuisance than a problem unless the signal is very weak.
73,
Mike WA3KYY
At 11:58 AM 12/19/2006, you wrote:
>Anyone know if remoting the KPA100 to an EC-2 case reduces the birdie?
>
>--Mike
>
>
>At 10:32 AM 12/19/2006, Vic K2VCO wrote:
>>J F wrote:
>>>Just out of curiousity, after spending some time on
>>>10M during ARRL 10, I noticed a birdie around
>>>28.019/20. Is there a way to eliminate this or move it
>>>below 28.000?
>>
>>Yes, but even I haven't had the guts to implement it.
>>
>>Replace the diode t/r switch with a reed relay such as the
>>Matsushita RSD12V. Reduce the power level of the bias oscillator
>>and remove the high voltage multiplier section so you can get -12v
>>for the RS232 interface with less stray RF floating
>>around. Alternatively, find a way to power it from the computer
>>(and some RS232 ports will apparently work without the -12v at
>>all), so the bias oscillator can be completely disabled.
>>
>>I tried various forms of shielding, filtering and bypassing without
>>success. A friend pointed out to me that the birdie is a result of
>>mixing between VHF harmonics of this and another oscillator in the
>>K2, so that explains why it's so hard to kill.
>>--
>>73,
>>Vic, K2VCO
>>Fresno CA
>>http://www.qsl.net/k2vco
>>_______________________________________________
>>Elecraft mailing list
>>Post to: Elecraft at mailman.qth.net
>>You must be a subscriber to post to the list.
>>Subscriber Info (Addr. Change, sub, unsub etc.):
>>http://mailman.qth.net/mailman/listinfo/elecraft
>>
>>Help: http://mailman.qth.net/subscribers.htm
>>Elecraft web page: http://www.elecraft.com
>
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
>http://mailman.qth.net/mailman/listinfo/elecraft
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com
More information about the Elecraft
mailing list