[Elecraft] KAT100 Query

[Ron D'Eau Claire]

Oops...typing too fast and stumbled over my words, Hi. 

Clearly the RF IS available at the BNC, but that's not where you're expected
to attach the load. Ignore the BNC and use only the large Type N connector
on KPA100.

Ron AC7AC

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Ron D'Eau Claire
Sent: Sunday, December 17, 2006 7:03 PM
To: 'Glenn McNeil'; Elecraft at mailman.qth.net
Subject: RE: [Elecraft] KAT100 Query


Hi, Glenn: 

The Owner's Manual will show you to connect the transverters to the output
of the KPA100, even if you're set to an output of 5 watts (see Figure 2 on
page 6 of the Owner's Manual). 

When you set the power to 10 watts or less the KPA100 is in bypass, but the
RF is still routed to the large connector on the KPA100, not to the BNC. 

Ron AC7AC