[Elecraft] KDSP2 questions

[Chuck Guenther]

Don and Lyle,

It's working!  I removed the KDSP2 module and heated up a couple of dozen
solder connections, especially at the connoectors.  While I was at it I
built the KNB2 module and installed it.  I used the audio filter un-module
from Rework Eliminators to replace the KDSP2 module while I checked out the
KNB2.  Then I reinstalled the KDSP2 and now have solid communications with
it.

Thanks to both of you for your assistance.

73,
Chuck  NI0C

----- Original Message ----- 
From: "Don Wilhelm" <w3fpr at earthlink.net>
To: "Chuck Guenther" <ni0c at earthlink.net>
Cc: <elecraft at mailman.qth.net>
Sent: Wednesday, December 13, 2006 9:11 PM
Subject: RE: [Elecraft] KDSP2 questions


> Chuck,
>
> If you get the "not inst" message it means that the KDSP2 is not being
> recognized.
> The fact that it is intermittent indicates that there is a bad solder
> connection somewhere.
> You might try re-flowing the solder on the KDSP2 board.
>
> 73,
> Don W3FPR
>