[Elecraft] KDSP2 questions

[Chuck Guenther]

I assume you mean the rtc (real-time clock).  It is on (or at least starts
out that way, with power on).  However, after some time of operation, I get
"not inst."  The DSP filters work fine-- I just can't call them up in the
menu to edit them or make changes without doing the power on/off.

So far have not heard from Elecraft support on this.

73,
Chuck  NI0C

----- Original Message ----- 
From: "Jean-François Ménard" <va2vyz at yahoo.ca>
To: "Chuck Guenther" <ni0c at earthlink.net>; <elecraft at mailman.qth.net>
Sent: Wednesday, December 13, 2006 8:16 AM
Subject: Re : [Elecraft] KDSP2 questions


Just switch ON clock in SECondary K2 menu

----- Message initial ----
De : Chuck Guenther <ni0c at earthlink.net>
À : elecraft at mailman.qth.net
Envoyé le : mercredi 13 décembre 2006, 08 h 22 min 38 s
Objet : [Elecraft] KDSP2 questions



2.) Referring to the KDSP2 Manual, page 38, troubleshooting:  The middle of
the page gives the following symptom (which I experience frequently): "AFIL
works but I can't access DSP or clock menus when I press Display"  The
manual goes on to suggest turning the K2 off then back on.  This works for
me, but is there a better fix for this?  The manual also says to "let us
know" if this happens frequently.  I have e-mailed Elecraft support
regarding this.

__________________________________________________
Do You Yahoo!?
En finir avec le spam? Yahoo! Courriel vous offre la meilleure protection
possible contre les messages non nollicités
http://mail.yahoo.ca Yahoo! Courriel