[Elecraft] Solvent

[peter gerba]

I wouldn't clean the boards.

I didn't on mine.

If you do, with alcohol, be sure not to use Completely Denatured Alcohol. It
is a serious poison and can be absorbed via your skin. It contains  brucine,
very nasty stuff.

Be careful. I'm sure your boards will be fine if you use good solder and
solder carefully.

pete, kn6bi

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net]On Behalf Of Doug Faunt N6TQS
+1-510-655-8604
Sent: Wednesday, December 13, 2006 10:08 AM
To: jim at jtmiller.com
Cc: elecraft at mailman.qth.net
Subject: Re: [Elecraft] Solvent


At least around here, 99% isopropyl is readily available, and is only
slightly more expensive.

73, doug

   From: "Jim Miller" <jim at jtmiller.com>
   Date: Wed, 13 Dec 2006 12:30:24 -0500

   If you go to the drug store and look closely you can find 91% isopropyl
   alcohol. The remaining 9% is water which won't hurt anything.

   Works fine esp with acid brush previously mentioned.

   73

   jim ab3cv
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

__________ NOD32 1919 (20061213) Information __________

This message was checked by NOD32 antivirus system.
http://www.eset.com