[Elecraft] K2 Firmware request

[Tom Althoff]

I should have said "..so I could store 28.025 as CW on VFO-A and 28.500 as
USB on VFO-B"

----- Original Message ----- 
From: "Tom Althoff" <althoff at verizon.net>
To: "Elecraft" <elecraft at mailman.qth.net>
Sent: Saturday, December 09, 2006 7:37 AM
Subject: [Elecraft] K2 Firmware request


I'm sure this has been asked before but I sure would like to have VFO-B have
its own 'mode' register so I could store 28.025 as CW and 28.500 as USB.

Is that possible or is there no room at the inn?

Also, does the RS-232 command set allow querying which VFO is active?   I
use B for SSB during contests and A for CW.

Tom K2TA
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com