[Elecraft] K2 Alignment and Test, Part III

[Scheidler, Dale A.]

I have a K2 and have completed up to page 74.  On page 75 the 40-Meter
Transmitter Alignment did not work.  When in TUNE, my readings are .3 on
the built-in wattmeter.  Adjusting L1 and L2 does not make any change.
"If you cannot get power output to 2.0 watts or higher, see
Troubleshooting".  There is no increase.  There is a 50 ohm dummy load
hooked to the antenna bnc.   Could someone please let me know if there
is MENUE or EDIT function that may not be enabled?  Should I go directly
to the Trouble shooting and take measurements?  

 

Thank you,

Dale, kc9cwb