[Elecraft] Heil Handi Mic
Mike Short
mike.short at mchsi.com
Mon Dec 4 18:38:48 EST 2006
I am using the Heil HM-5, and the audio is just fine according to reports.
I didn't have to do anything special. I set SSb A menu to 2, and SSbB menu
to 3-1,
And it works well for my voice.
Just another option.
Mike
AI4NS
-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Don Wilhelm
Sent: Monday, December 04, 2006 12:57 PM
To: Frank Van Cleef W1WCG; elecraft at mailman.qth.net
Subject: RE: [Elecraft] Heil Handi Mic
Frank,
Unfortunately the Heil HC-4 and HC-5 elements have lower output than typical
mics. There is one in the Handi-Mic set that should work well with the K2 -
and that is the one for the Icom (Heil number HM-iC) perhaps you could
arrange an exchange.
In general the Icom mics use an electret element with high output level -
the audio input needs of the K2 and the Icom are similar.
If you do wish to retain the HC-5 element, then your best choice is to use a
pre-amp. There are work-arounds such as changing the value of KSB2 R14, but
IMHO, the best all-around solution is to use a pre-amp and set the pre-amp
gain to provide the output needed by the K2. If I recall correctly, the
proper output level is -40 dBm.
73,
Don W3FPR
> -----Original Message-----
>
> I recently acquired a Heil Handi-Mic with the HC-5 element,
> intending to use
> it with a new K2 radio (#5510). I used straight-across wiring for the
> configuration connector in the front panel since the Handi-Mic is
> equipped
> with a cable wired for Kenwood mikes. No resistor from pin 1 to
> pin 6 since
> the element is dynamic. The mike does work, but the output seems
> low -- the
> ALC indication barely lights the top bar, and the RF output
> barely shows on
> the louder peaks. A MH-2 mike shows a little more output, though
> not that
> much more. The over-all feeling is that the Handi-Mic has a
> relatively low
> output level and may need a preamp to work properly with the K2.
>
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.430 / Virus Database: 268.15.6/567 - Release Date: 12/4/2006
7:18 AM
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
More information about the Elecraft
mailing list