[Elecraft] K2 Front Panel Extension

[Darwin, Keith]

Well, that's a good question.  Here's my initial list:
  Xfil 1
  Xfil 2
  Xfil 3
  Xfil 4
  USB
  LSB
  CW
  VFO Speed 1
  VFO Speed 2
  VFO Speed 3
  AGC_F
  AGC_S
  AGC_0
  Atten
  PreAmp

... But it doesn't end there because I want more than just buttons.  I
also want knobs:

  VFO (larger knob mainly)
  SideTone Vol (and a ST_Vol on/off switch to go with the pot)
  
... And, the most import part

  Analog S-meter showing RX S-units & TX output (or ALC)


I'm not sure all of this is available or workable via. RS-232.  I do
agree that a dedicated front panel would be far better than SW on a PC
because I don't want to be tied to a PC either in the shack or esp. on
the road.

- Keith KD1E -
- K2 5411 -

-----Original Message-----
From: Robert B (Bob)
	Question for everyone: If there would be a small hardware front
panel extension with say 16 or 20 pushbuttons and LEDs (either
associated with the buttons or for independent functions), what
functions would you most want?

73

Bob W1SRB