[Elecraft] Controllerboard

Adolf Loosen nc-loosenad at netcologne.de
Sun Aug 27 11:36:05 EDT 2006

Previous message: [Elecraft] K3 in the works in near future?
Next message: [Elecraft] K2 DC Ripple Requirements?
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Hello.
I built my first K2
After the inspection of the controllerboard I make the resistance checks 
and then i have a problem

The resistance at P2,U5 ,U4 and U3 are correct.
The others are too low ,by U6 not > 100 k it was ca.35k,by U8 the same.
and by Q1 and Q2 only 35k.

Is that correct.?
Please excuse my bad english
vy 73 de adolf  DL6KL
German Radio amateur

Previous message: [Elecraft] K3 in the works in near future?
Next message: [Elecraft] K2 DC Ripple Requirements?
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

More information about the Elecraft mailing list