[Elecraft] First Alignment and Test problem #5703

[John Reiser]

Hi Bill,

When you did your resistance checks for the front panel board, were any of 
them outside of the expected range on the low side?

John, W2GW

----- Original Message ----- 
From: "Bill Carpenter" <NZ0T at cox.net>
To: "elecraft list" <elecraft at mailman.qth.net>
Sent: Thursday, August 24, 2006 11:52 PM
Subject: [Elecraft] First Alignment and Test problem #5703


>I got to the first test stage tonight and while the rig came on with no 
>smoke there is nothing on the LCD display. I hear the relays clicking and 
>the backlight is on but no characters at all.  The front panel is plugged 
>in fine and I reset it just to make sure.  Dittos for the control board. 
>All the intermediate resistance checks were.  Any input as to where to 
>start looking would be appreciated!
>
> Thanks and 73,
>
> Bill NZ0T
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>