[Elecraft] NGEN/XG-2 Project

[Paul T. Rubin]

Hello All:

 

I'm putting a NGEN and an XG-2 in a small project case. Assuming that both
devices would not be on at the same time, would there be some way to couple
the outputs to a single BNC connector, without using a switch, and without
degrading the performance of the XG-2?

 

Also will I have any problems with stability by extending the leads for the
crystal switch a few inches?

 

Also does anyone know of a source for a small three position single gang
rotary switch to mount on the case to replace the switch on the XG-2 board?

 

On a totally different question. Does anyone have any experience with
internal lithium polymer battery packs for the K1 or KX1?

 

As always, thanks in advance for all the information I learn on this
reflector.

 

Paul N8NOV