[Elecraft] K2, Freq readout

[Robert Tellefsen]

Carel
If you listen to WWV, or some other equally accurate signal, with
no modulation, just pure carrier, you should be right on 10.000 IF
you are zero beat with your SPOT tone in CW, or are zero beat in
SSB mode.  It is easiest to check for zero beat in ssb by switching
back and forth between LSB and USB until both sound the same when
there is AM modulation on the signal.
Good luck and 73
Bob N6WG

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net]On Behalf Of pc5m, Carel
Sent: Sunday, April 30, 2006 9:01 AM
To: Elecraft at mailman.qth.net
Subject: [Elecraft] K2, Freq readout


Struggling to get the freq readout of my k2 correct (using various methods
as described on w3fpr's website).

 

Now I am doubting everything (including myself..) so, but to be sure..

 

What should the readout on the K2 displaying, If I had a carrier at 10.000
MHz and tune it in CW, USB and LSB to have it at 600 Hz tone (equal to my
spot tone) ?

 

Thanks in advance,

 

Carel.

 

 

 

 

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com