[Elecraft] K2 BANDS - How?

[Dave]

Fred

Welcome to the Elecraft club, membership lasts a long time!

The K2 returns to the last used frequency when you power it up, other 
than that the bands just cycle round. Assuming you haven't set any 
transverter bands pressing down from 1.8 MHz takes you to the 28 MHz 
band, etc. Moving around the band is just a matter of rotating the 
tuning knob or pressing the "rate" switch then the knob. The K2 
remembers the last used frequency, mode and KAT2 settings for each band.

If there was a rotary band switch, it would create problems with 
transverter bands which are hidden unless you set them in the menu.

I have a TS570, FT857, K1 and K2. I don't find navigating my way around 
the K2 at all difficult.

73 Dave, G4AON